- Cover the feed hole on the front
of the cartridge with the seal dot
or adhesive tape.
- Using the drill, make a fill hole
on top of the cartridge in the
back area where the label
does
not cover.
- Remove the cap from the correct
color ink bottle and insert the
needle through the fill hole.
- SLOWLY squeeze the bottle injecting
ink into the cartridge.
- The ink will be absorbed by the sponge in the adjacent
reservoir. Give it a minute to be absorbed and continue
filling.
6. DO NOT OVERFILL.
- Replace the cap on the ink bottle and blot away excess
ink.
- Firmly insert the small plug in the fill hole. Make an AIRTIGHT
seal. Remove the seal dot from the feed hole.
- If the cartridge leaks, reseal the feed hole and reseat the
plug in the fill hole.
- Install in the printer.
