Kodak: #10

Jump to:

HOME

INDEX

General Instructions

Cleaning Solution Instructions

Chip Resetter

Tools required:

• Drill
• Syringe
• Ink
• Tape
• Paper towels

1. Place the Kodak #10 cartridge on a flat surface over some paper towels to collect any spilled ink.
2. Pry open the lid on the top of the color cartridge to expose the ink chambers.
3. Fill a syringe with 5 ml. of the color ink to refill.
4. Insert a toothpick into the refill holes on the color cartridge to ascertain the color of the ink in each chamber.
5. Insert the needle of the ink syringe into the appropriate ink chamber.
6. SLOWLY inject the ink into the cartridge.
7. Fill the other color ink chambers the same way with the corresponding ink syringe.
8. Press the lid onto the top of the color cartridge until it snaps back into place. Apply a strip of tape around the lid seal to hold it in place.
9. Drill a hole in the top of the black cartridge on the letter "K" in "Kodak."
10. Fill a syringe with 15 ml. of black ink.
11. Insert the needle of the syringe into the drilled hole. Slowly inject the ink into the ink chamber.
12. Replace the cartridges in the printer.
13. You may need to let the cartridge rest to allow the ink to saturate the internal sponges

 

All brand names, model names and cartridge numbers are trademarks of their respective owners. This product is not affiliated with nor endorsed by those manufacturers.