- Using the drill, make three
holes in the lid of the cartridge.
Alternatively, you can
pry the cartridge cap off
with a knife.
- You MUST fill all three
chambers in the black cartridge.
- Remove the cap from the
correct color ink bottle and insert the needle through the
appropriate fill hole.
- SLOWLY squeeze the bottle
injecting ink into the cartridge.
- Go SLOW or the ink will mix
in the printhead.
- DO NOT OVERFILL.
- Replace the cap on the ink
bottle and blot away excess
ink.
- Seal the fill holes with adhesive tape. If the cap was removed,
tape it back onto the cartridge body.
- Install in the printer.
