- Seal the maze hole on the bottom of the
cartridge and the air vent on top with
adhesive tape or two blue seal dots.
- .Use the drill to make a hole in the back
corner of the cap. DO NOT drill through
the soft plastic air vent.
- Remove the cap from the black ink bottle
and insert the needle through the fill
hole.
- SLOWLY squeeze the bottle injecting ink
into the cartridge.
- DO NOT OVERFILL.
- Replace the cap on the ink bottle and
blot away excess ink.
- Firmly seat the small plug in the fill hole.
- Remove the tape or seal dot from the top of the cartridge.
- If ink drips from the bottom, place the inflator bulb into
the vent hole and squeeze to pump air into the cartridge.
Remove the bulb before releasing the squeeze. Repeat
until the dripping stops.
- Remove the tape or seal dot from the bottom maze hole.
- Install in printer.
