- Locate the fill holes under the
label by running your finger
across the middle of the
cartridge. Use the center hole for
black and all three holes for the
color cartridge. - Make a fill hole through the label
with the eyescrew. - Remove the cap from the correct
color ink bottle and insert the
needle through the fill hole.
- SLOWLY squeeze the bottle injecting ink into the cartridge.
- DO NOT OVERFILL.
- Replace the cap on the bottle and blot away excess ink.
- Seal the fill holes with adhesive tape.
Note: Most printers that use these
cartridges incorporate a fill gauge in
the software drivers. This gauge can
be disabled by following the
directions in the printer manual.
