- Seal each feed hole with adhesive tape.
- Use the eyescrew to make fill holes in the
depression under the label in the center of
each ink chamber.
- Remove the cap from the correct color ink
bottle and insert the needle through the fill
hole.
- SLOWLY squeeze the bottle
injecting ink into the cartridge.
Rest 1 minute and repeat. DO
NOT OVERFILL.
- Replace the cap on the ink bottle
and blot away excess ink.
- Seal (airtight) the fill holes with
tape. DO NOT seal the vent
channels. DO NOT remove the
tape from feed holes.
- Install in the printer.
* Cartridges use smartchip technology and MUST be reset. Click here for details.
