- Seal the feed hole on the
front of the cartridge
with the seal dot or tape.
- Peel back the label over
the back side of the cartridge.
- Use a pen to push the fill
hole ball into the cartridge.
The ball may be on the bottom of some cartridges.
- Remove the cap from the correct color ink bottle and insert
the needle through the fill hole.
- SLOWLY squeeze the bottle injecting ink into the cartridge.
- DO NOT OVERFILL. No higher than the top of the foam.
- Replace the cap on the ink bottle and blot away excess
ink.
- Insert the large plug into the fill hole. Reseal the plug with
the label and secure it with tape.
- Remove the seal dot. If the cartridge leaks excessively,
reseal the fill hole so that it is airtight.
- Install in the printer.
