- Seal the feed hole in the bottom
of the cartridge with tape
or a seal dot.
- Using the drill, make a fill hole
in the top of the cartridge over
the reservoir. The label does
not cover this area and there is
no sponge in the reservoir.
- DO NOT drill into the sponge
area.
- Remove the cap from the correct
color ink bottle and insert
the needle through the fill
hole.
- SLOWLY squeeze the bottle injecting ink into the cartridge.
- DO NOT OVERFILL. No higher than the top of the foam.
- Replace the cap on the ink bottle and blot away excess
ink.
- Seal the fill hole with the small plug. Ensure it is airtight.
- Remove the feed hole seal dot and install in the printer.
- If the cartridges drips excessively, reseal the feed hole and
reinsert the plug making an airtight seal.
