- Cut label at joint between top and
bottom halves of cartridge case.
- Open the cartridge shell.
- Remove cartridge from the shell.
- Drill through the rubber stopper in the round well on top
of the cartridge. DO NOT PRESS THE PRESSURE RELEASE
BUTTON.
- Insert the needle into the cartridge. BE
SURE NOT TO PUNCTURE THE BAG INSIDE.
- Slowly inject up to 15 ml of ink into the
cartridge.
- Remove the needle and seal the hole
with the plug. Tape the plug down.
- Place the cartridge back into the shell and tape the two
halves of the shell together.
- Install the cartridge in
the printer.
