- Seal the feed hole on the bottom
with tape or a seal dot.
- Grab the “handle” of the cartridge
cap and remove. (Use a small screw
driver to pry off). Do NOT remove
for the LC‐41.
- Locate the larger of the two round
silver seals on the top.
- Using the drill, make a hole in the
silver seal where it overlaps the
foam. LC‐41: insert needle in the
vent hole in the top.
- Remove the cap from the correct
color ink bottle and insert the needle
into the foam through the fill hole.
- SLOWLY squeeze the bottle injecting
ink into the cartridge.
- DO NOT OVERFILL.
- Replace the cap on the ink bottle
and blot away excess ink.
- Seal the fill hole with tape. Ensure a GOOD seal, or the
cartridge will leak. Put the cap back on the cartridge.
- Remove the feed hole seal and install in the printer.
